FMC Steritort Test Equipment

(#S28) The Rotary Contactor is used when heat penetration testing is conducted on cans that rotate on their axis, in an FMC Steritort.

(#ESR-HUB) The Steritort Hub is an 18-circuit "hub" that can be installed into an FMC Steritort for conducting heat penetration testing.

(#S30) When heat penetration testing is conducted on rolling cans in an FMC Steritort, specialized equipment is needed.

When heat penetration testing is conducted on rolling cans in an FMC Steritort, specialized equipment is needed.

(#S34) The Surface Mount Connector Protective Cap is used to cover a Surface Mount Con

Rotary CALPlex is a datalogger designed for installation directly on the back of a rotary retort INSTEAD OF the traditional thermocouple slipring.

The CALSoft™ software was designed by TechniCAL specifically for Process Authorities in the retorted canned foods industry.

(#CNS) Ecklund Needle Thermocouples are specially designed for conducting heat penetration tests of foods in cans, jars, and plastic packages.

Receptacles are stainless steel fittings made specific

Temperature Distribution (TD) lead wires (also referred to as "Free Leads") are used to measure the temperature of the retort heating medium OUTSIDE the product-filled containers.

(#C24FL-2) A specially designed “flange type” Packing Gland made of aluminum and stainless steel fittings allows for the wires to be installed through the retort shell without loss of steam pressur

A Combination Can Punch and Countersink (#C11) is a two-part draw-through tool that is used to manually punch a hole in the bottom of a can.

(#C14S) A specially designed Spanner Wrench is used to tighten an Ecklund Needle Thermocouple in a re

(#C13) A specially designed End Wrench is used to tighten an Ecklund Thermocouple Receptacle&

(#C17) Thermocouple Gaskets are made specifically for Ecklund Needle Thermocouples.

There are two different types of receptacle gaskets available for purchase.